|
|
Large Scale Surge Suppression - Liebert's
wide range of transient voltage surge suppression (TVSS) products
has numerous applications throughout a facility. The IEEE
recommended practice is to install TVSS protection on every
electrical conductor that penetrates the facility shell.
 |
The
Liebert Type SS utilizes advanced SAD/MOV array technology
for industry leading transient suppression voltages. |
PowerSure Panel TVSS - 60Hz
 |
The
PowerSure Panel TVSS is available in a low and medium
surge suppression system. |
Accuvar - 60Hz
 |
A
full line of multi-phase, multi-mode distribution panel-mounted
surge suppression devices. |
Hybrid Advantage - 60Hz
 |
The
Liebert Hybrid Advantage is the first hybrid product in
the industry to offer a true coordinated multi-stage system
of suppression. Surge current capacity ranges from 100kA
to 400kA per phase. |
Interceptor II TVSS Series - 60Hz
 |
A
unit built to provide the highest level of surge current
capacity, with the lowest clamping voltages. Along with
true NEMA 4 assembly suitable for outdoor use. |
Interceptor ATF Series - 60Hz
 |
A
customized, modular approach to surge protection in a
series filter device. The Interceptor Series utilizes
MOV (metal-oxide varistor) technology. |
Interceptor TVSS Series - 60Hz
 |
A
customized, modular approach to surge protection in either
a parallel or series filter device. The Interceptor Series
utilizes MOV (metal-oxide varistor) technology. 30-4000
amp capacities. |
LM Series - 60Hz
 |
The
LM Series offers continuous protection from damaging transients
and electrical line noise, and it has the industry's highest
surge current repeatability. Surge suppression levels
range from 50kA to 400kA per phase. |
PanelGuard Extension - 60Hz
 |
The
PanelGuard Extension is an add-on device for integration
with panelboards at the jobsite for enhanced surge suppression.
Surge current capacity levels range from 100kA to 200kA
per phase. |
Specialty Surge Suppression - this
wide range of surge protection devices is designed for data
line, telecommunications and other specialty applications.
AccuGuide
- 60HZ
 |
AccuGuide
interconnect assemblies can maximize performance by transmitting
transients generated by lightning and switching with minimal
voltage drops. Voltage ranges from 0 to 600. |
HSDS Series - 60Hz
 |
Silicon
Avalanche Hybrid Protectors for low voltage data and telecommunications
applications, on pairs without the presence of ringing
voltage. |
Coaxial Protection - 60Hz
 |
These
coaxial surge suppression devices are designed for specialty
applications such as repeater/duplexer antennas and other
radio type communications, offering low loss even at frequencies
approaching 500 Mhz. |
Flow Meter Protection - 60Hz
 |
Transient
voltage suppressors designed for the water and waste water
industry. These multistage hybrid suppressor address overvoltage
transient with gas tube and silicon avalanche technology. |
SND Series - 60Hz
 |
Designed
specifically for medium exposure applications protecting
sound systems, the SND Series surge protectors can be
used on pairs inside a building or leaving the building
in conduit up to 500 feet. |
LTS 1 Series - 60Hz
 |
This
advanced, solidstate primary telecommunications protection
module fits any industry standard five-pin building entrance
protector housing. |
LRA 5 Pin Module - 60Hz
 |
This
data/telephone line protection module fits any industry
standard five-pin building entrance protector housing.
Provides over-voltage clamping, as well as over-current
protection. |
LBT42 Series - 60Hz
 |
Data/Signal
line surge suppressor is a dual pair (four wire) module
implementing three stage hybrid technology. This plug-in
module addresses over-voltage transients, as well as sneak
and fault currents. |
Tel-200 Series - 60Hz
 |
Fused,
solid state secondary protectors of Key/PABX C.O. (Central
Office) trunk pairs. Available in two different circuit
configurations. |
SBG Ground Rail - 60Hz
 |
High
density design allows multiple Liebert surge suppression
devices to access ground when used with the 66MI-50 Punch
Down Block. |
LTAC Series - 60Hz
 |
The
LTAC Series surge suppressor was specifically designed
to protect electronic instruments used by the water industry,
combining hybrid AC power protection and signal line protection. |
LBT64 Series - 60Hz
 |
Data/Signal
line surge suppressor implementing three stage hybrid
technology. Addresses lighting, over-voltage transients,
common mode noise and other line threats. |
LBT52 Series - 60Hz
 |
Lighting
and surge protection for alarm and security systems. Protects
two pairs of wires, and operating currents as high as
2.5 amps. |
LBT-232 Series - 60Hz
 |
State-of-the-art
surge protector with silicon avalanche clamp devices.
Ideal for IEEE Std. RS-232C peripheral devices. |
LBLAN-24 - 60Hz
 |
High-density
housing for up to six Liebert LAN Protection Modules [for
TYPE 110 (AT&T) connection system]. The protection modules
are sold separately from the LBLAN-24 assembly. |
CL Series - 60Hz
 |
Designed
for CCTV, Data and Audio applications, the CL Series surge
suppressor is a single coax line protector implementing
three-stage hybrid technology. |
|
|
|
